Use (the machine is not dedicated foam method of operation, that is, the use of manual operation) 
 Measure 
 A solution, B solution is the weight mixing ratio: 1:1 with a paper cup or other container first weighed amount A solution, then with the other cup or other container, weighed with the weight of liquid B, please accurately weighed, A solution and B the amount of fluid consistent if the weight bias is too large, may cause the surface can not be cured or completely cured to cured color deviations occur. 
 (2) Mixed 
 The main method is accurate to say the B solution into the A solution, then with metal spatula or glass rod, stir (preferably with an electric drill mixing), if uneven mixing, may cause the surface can not be cured completely cured or the color of cured deviations occur. Note: the mixing time of 30 seconds is appropriate, because A and B liquid mixed fluid at 1.5 to 2 minutes of curing, so the sooner the better hours of operation. (winter low temperature, then be first A, B material separate mixing, then mixing) 
 (3) irrigation mode 
 Fully stirred, and rapidly poured into the silicone mold, the mold must be set aside out of holes, because the reaction process will produce gas, and the volume will Peng Zhang. 
 (4) Stripping 
 AB will be a good filling material silicone mold placed flat bench, to be 15 to 25 minutes, you can mold, due to curing reaction heat will increase the temperature of cured, careful to avoid scalding accidents, if the early ejection, high temperature curing due to chilling, deformation may occur